6 Printing from Macintosh
320 Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x
- Middle Bottom (Portrait)/Middle Left (Landscape) — Select this to staple double in the
bottom for the portrait document, or in the left for the landscape document.
- Saddle Stitch (Portrait)/Saddle Stitch (Landscape) — Select this to staple double in
the center for a booklet to be printed. Select this only when booklet printing is performed.
y This option cannot be selected if a finisher is not installed.
y “Saddle Stitch (Portrait)/Saddle Stitch (Landscape)” can be selected only when the Sad-
dle Stitch Finisher is installed.
y Depending on the type of finisher installed and destination settings, stapling and hole
punching may not be performed. Depending on the equipment settings, the paper may
be delivered to a tray that cannot carry out stapling or hole punching when "Auto" is
selected as the "Destination" option.
— DC (Department Code)
In the DC menu, you can specify your department code, if this equipment is enabled the depart-
ment codes. Before specifying the department code, you must check the Department Code
option in the Printing Modes menu. Then specify the department code in this menu.
1
2
3
4
5
To Next Page
Loading...
