Printing from Application on Mac OS 8.6 to 9.x 331
y Depending on the type of finisher installed and destination settings, stapling and hole
punching may not be performed.
y Depending on the equipment settings, the paper may be delivered to a tray that cannot
carry out stapling or hole punching when “Auto” is selected as the “Destination” option.
y “Tray 1” and “Tray 2” can be selected when the Hanging Finisher, Finisher, or Saddle
Stitch Finisher are installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off
— Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
This option cannot be selected if a hole punch unit is not installed.
To Next Page
Loading...
