1 TROUBLESHOOTING FOR THE HARDWARE
26 Clearing a Paper Misfeed
7
Close the automatic duplexing unit cover.
Paper misfeed in the Bridge Kit
3
Close the Bridge Kit cover.
Paper misfeed in the Finisher and the Hole Punch Unit
Paper misfeed in the upper receiving tray
6
When the finisher is installed, close the Bridge Kit
cover.
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right
side is caught by the fuser unit, follow the steps on P. 2 4
“Paper misfeed in the fuser unit”.
1
Raise the lever and open the upper receiving tray of
the finisher.
2
1
To Next Page
Loading...
Need help?
General
