2 TROUBLESHOOTING FOR COPYING
Copying Problems 75
Copy image is skewed. The original is sent from the
Reversing Automatic
Document Feeder at a skew.
Replace the original while aligning the side
guides of the Reversing Automatic Document
Feeder to its width so that it will be placed
straight.
The gap between the paper
and the side guides in the
drawer or the bypass tray is
too large.
Adjust the gap between the paper and the side
guides so that it becomes appropriate.
For details, refer to Chapter 1 and 2 of the
Copying Guide.
Copied image is partially
missing.
The size or orientation of the
copy paper and that of the
original are not consistent.
The reduction ratio is not
properly set.
Fit the copy paper size to the original or set
the reduction ratio for the copy paper.
The binding margin is too
wide.
Set the binding margin width to fully cover the
original.
For details, refer to Chapter 4 of the Copying
Guide.
The original is larger than the
printable area.
The outside part of the printable area cannot
be copied. The Full Image function enables
you to copy the whole image of the original in
the 95 - 99% reduction ratio.
Copied image is blurred. There is a gap between the
original glass and the original.
Lower the Original Cover or the Reversing
Automatic Document Feeder fully so that the
original fully contacts the platen glass.
The copy paper is damp. Replace it with dry copy paper.
Copied image has
unevenness in the
horizontal direction.
The main charger is stained. Clean the main charger.
P.67 “Cleaning the Main Chargers and LED
Print Heads”
Problem Description Cause Corrective Action
To Next Page
Loading...
Need help?
General
