Toshiba e-STUDIO 450 - Standard Copying Procedure; Step-by-Step Copying Guide

51
2
5
Enter current department code in the
“Current Code” field using the digital
keys, and then press the [SET] button to
set the entry.
- If you enter the code, asterisks (*) appear in the “Current Code”
field.
- If you want to clear the code to retype it, press the [CLEAR] button
on the Control Panel.
- After pressing the [SET] button, the “New Code” field is
highlighted.
6
Enter new 5-digit code in the “New Code”
field using the digital keys, and then press
the [SET] button to set the entry.
- If you enter the code, asterisks (*) appear in the “New Code” field.
- If you want to clear the code to retype it, press the [CLEAR] button
on the Control Panel.
- After pressing the [SET] button, the “Retype New Code” field is
highlighted.
The department code must be the 5-digit code except “00000”.
If you want to return to the “Current Code” field to retype it, press the
[RESET] button.
7
Enter new 5-digit code again in the
“Retype New Code” field using the digital
keys, and then press the [SET] button to
set the entry.
- If you enter the code, asterisks (*) appear in the “Retype New
Code” field.
- If you want to clear the code to retype it, press the [CLEAR] button
on the Control Panel.
If you want to return to the “Current Code” field or “New Code” field
to retype them, press the [RESET] button.
8
Press the [ENTER] button at the bottom of
the touch panel.
- The LIMITATION screen is displayed.