8. Remote Scan
110 Scanning Guide — Installing Remote Scan Driver
Installing Remote Scan Driver
This section describes how to install the Remote Scan driver.
Planning for Installation
This equipment provides the Remote Scan driver that allows users to operate scanning
remotely from the Windows computer and import the scanned images into eCopy
ShareScan OP 3.0.
The Remote Scan driver can be used to operate scanning remotely and retrieve
scanned images into eCopy ShareScan OP 3.0 running on your computer. This soft-
ware can be used to retrieve scanned images into eCopy ShareScan OP 3.0.
The Remote Scan driver can connect to this equipment over TCP/IP network.
System Requirements
The Remote Scan driver is available for following environments:
•OS
Windows 2000 Service Pack 4
Windows XP Service Pack 1/Service Pack 2
• Required Software
Microsoft Internet Explorer 5.5 SP2 or later must be installed
eCopy ShareScan OP 3.0 must be installed
NOTE: To use the Remote Scan driver, the environments to operate the eCopy ShareScan OP
3.0 are also required. For the system requirements for eCopy ShareScan OP 3.0,
please refer to the documentation for eCopy ShareScan OP 3.0.
Installing the Remote Scan Driver
You can install the Remote Scan driver from the Client Utilities CD-ROM or TopAccess.
Installing from Client Utilities CD-ROM
This section describes how to install the Remote Scan driver.
The Remote Scan driver is available only when the Scanner Kit or Printer/Scanner
Kit is installed.
Connecting over TCP/IP Network
Remotely operate scanning
using Remote Scan driver
Retrieve scanned images
into eCopy ShareScan OP
Originals
Windows 2000
Windows XP
with eCopy ShareScan OP 3.0 is installed
Windows 2000
Windows XP
with eCopy ShareScan OP 3.0 is installed
To Next Page
Loading...
