8. Remote Scan
120 Scanning Guide — How to User Remote Scan Driver
Configuring Discovery Settings
You can configure the discovery settings.
1) Devices
Click the arrow button to display the poll down list and check the model name that
you want to search.
2) Network - Enable IPX/SPX Search
This is disabled because the Remote Scan driver does not support the IPX/SPX
connection.
3) Network - Enable TCP/IP Search
Select this to search for devices connected to the TCP/IP network. This is available
only when the TCP/IP protocol is installed.
When this is enabled, select how it searches devices in the TCP/IP network.
- Search local subnet — Select this to search devices in local subnet.
- Specify a range — Select this to search devices in specific range of IP
addresses. When this is selected, enter the IP addresses in “From” field and
“To” field to specify the range.
To Next Page
Loading...
