4. Scan to E-mail
Scanning Guide — How to Perform Scan to E-mail 45
4. When the AUTHENTICATION screen is displayed, enter the
user name and password by pressing the [USER NAME] and
[PASSWORD] buttons, and press the [ENTER] button.
• When pressing each button, the letter entry screen is displayed. Enter the
value using the keyboard and digital keys, and press the [ENTER] button to
set the entry.
NOTE: This screen is displayed only when the User Authentication for Scan to E-mail is
enabled. When this screen is displayed, you must enter your user name and password
to login the SCAN TO E-MAIL screen. For user name and password, ask your network
administrator.
5. Specify the E-mail addresses that you want to send, and
press the [SETTINGS] button.
• You can specify the E-mail address by various ways. See the following pro-
cedures for each instruction.
P.50 "Specifying Destinations"
SUPPLEMENT: You can press the [START] button to start sending the E-mail at this screen if you spec-
ify an E-mail address and the From Address has been set in TopAccess E-mail setting
page or set by the User Authentication for Scan to E-mail setting.
To Next Page
Loading...
