Toshiba e-STUDIO 520 - Changing the Default Values; Deleting the Print Queue

4 Installing Client Software for UNIX
204 Setting Up the UNIX Filters
Creating a print queue manually on OpenUNIX
1
Log on to the root account.
2
Open your Linux/UNIX editor.
3
Create the following file.
/etc/lp/interfaces/<queue name>.conf
4
Add a line as below in the <queue name>.conf.
dest=<IP address>
5
Save the file.
6
Enter the following command:
chmod +x <queue name>.conf
7
Enter the following command:
chown lp:lp <queue name>.conf
8
Enter the following command:
lpadmin -p <queue name> -v /dev/null -I any \
-i /usr/lib/lp/model/net_estbw
9
Enter the following command:
accept <queue name>
10
Enter the following command:
enable <queue name>
Changing the Default Values
You can change the default values of a print queue by the following procedure.
Changing the default values of a print queue
1
Study the interface file, named <queue name>, stored in the /etc/lp/
interfaces directory.
y This file contains all of the default settings and values that can be set. These values
are case sensitive and must conform to the /bin/sh variable format.
2
To manually edit the configuration file (/etc/lp/interfaces/<queue
name>.conf), add a line that consists of the parameter and value.
y For example, to change the default orientation to Landscape, add the following line:
orient= “LANDSCAPE”
Deleting the Print Queue
There are two ways to delete the print queue: one is deleting a print queue using estbwrm, and
the other is deleting a print queue manually without using estbwrm.
 P.205 “Deleting a Print Queue Using estbwrm”
 P.205 “Deleting a Print Queue Manually”