7 Printing from UNIX
348 Printing from an Application
Paper Source
The paper source can be selected using the following options.
In PostScript Deferred Media Selection is always turned on so the paper size has priority over
the paper source. In PCL5e the paper size always has priority over the paper source.
If this option is not specified the command will not be sent so the printer’s default value will be
used.
Example: The command to specify the LCF paper source is “lp - o lcf filename”.
Duplexing
The current duplex mode can be specified using the following options.
If this option is not specified, the default value “simplex” will be used.
It is not necessary to specify duplexing for Booklet Mode (sduplex). Setting duplexing separately
can override the booklet mode setting for duplexing.
Example: The command to specify long edge duplexing is “lp -o duplex filename”.
Option Value
Alternate
Value
Description
auto-source Select auto paper tray selection.
manual Select Bypass Tray.
drawer1 upper
cas1
Select the 1st drawer.
drawer2 lower
cas2
Select the 2nd drawer.
drawer3 pedupper
cas3
Select the 3rd drawer.
drawer4 pedlower
cas4
Select the 4th drawer.
LCF lcf Select the LCF. LCF is not available for some countries
or regions.
lcf tandem Select the LCF. LCF is not available for some countries
or regions.
external Select the external LCF.
Option Value
Alternate
Value
Description
simplex Turn duplexing off.
duplex lduplex
duplex_long
duplex=long
hduplex
Turn duplexing on with long edge binding.
sduplex duplex_short
duplex=short
vduplex
Turn duplexing on with short edge binding.
To Next Page
Loading...
