Toshiba e-STUDIO 520 - Page Layout

7 Printing from UNIX
352 Printing from an Application
In a job, if this value is LT, and in PDL too the data is for LT paper size, this will result in a scaled
booklet on Letter paper. In a job, if this value is A3, and in PDL the data is for A4 paper size, this
will result in a tiled booklet on A3 paper.
When the Booklet Mode options is selected, the paper size is automatically set to the same size
as for Booklet Mode. This function is only available for A3, A4, B4, Letter and Ledger paper
sizes.
If booklet mode is selected, then duplexing is also selected automatically (sduplex). Setting
duplexing separately can override the booklet mode setting for duplexing.
Example: The command to select the letter size paper for booklet printing mode is
“lp –o booklet=letter filename”.
Page Layout
The booklet mode page layout can be selected using the following options.
If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge
binding is used.
Example: The command to select left to right page layout for booklet printing mode is
“lp -o left2right=on filename”.
booklet=legal13 lg13
LG13
Select legal-13 size paper for booklet printing mode.
booklet=SQ85 sq85
letter-square
Select 8.5 inch square size paper for booklet printing
mode.
booklet=8K 8k Select 8K size paper for booklet printing mode.
booklet=16K 16k Select 16K size paper for booklet printing mode.
Option Value
Alternate
Value
Description
left2right=off OFF Select right to left page layout for booklet printing mode.
This value decides the layout of the pages in the book-
let.
If this value is OFF then the layout of pages is Right to
Left as shown in the figure below.
left2right=on ON Select left to right page layout for booklet printing mode.
This is the default setting.
If the value is ON then the layout of the pages is from
Left to Right as shown in the figure below.
Option Value
Alternate
Value
Description