Printing from an Application 353
Center Margin
The booklet mode center margin can be selected using the following options.
Example: The command to select the center margin value for booklet printing mode is
“lp -o centremargin=value filename”.
Outer Margin
The booklet mode outer margin can be selected using the following options.
Example: The command to select the outer margin value for booklet printing mode is
“lp -o outermargin=value filename”.
Collate
The collate option can be selected using the following options.
Example: The command to select collate off is “lp -o collate=off filename”.
Orientation
The following orientation options are available.
If this option is not specified the command will not be sent so the printer’s default value will be
used.
Example: The command to specify landscape orientation is “lp -o landscape filename”.
Option Value
Alternate
Value
Description
centermargin
=value
Select the center margin value for booklet printing
mode.
This value specifies in pixels the Center Margin or the
“Gutter”. This is in addition to the center margin already
specified by the application. The valid range for value is
0 - 300. Default is 0.
Option Value
Alternate
Value
Description
outermargin
=value
Select the outer margin value for booklet printing mode.
This value specifies in pixels the Outer Margin or the
“Creep” per page, which should take place while print-
ing a booklet. The valid range for value is 0 - . Default is
0.
Option Value
Alternate
Value
Description
collate=off OFF Cancel the collate printing mode.
collate=on ON Set the collate printing mode.
Option Value
Alternate
Value
Description
portrait Print the document in portrait orientation.
landscape Print the document in landscape orientation.
To Next Page
Loading...
