4 Installing Client Software for UNIX
216 Setting Up the CUPS
Finishing
Option Value Alternative Value Description
Destination Exit Tray
Tray 1
Tray 2
Select the destination.
Hole Punch Off
Long Edge Punch without rotation
Short Edge Punch without rotation
Long Edge Punch with 180 degree
rotation
Short Edge Punch with 180 degree
rotation
Select whether or not a print job is
hole punched.
Stapling Off
Upper Left (Portrait)/Upper Right
(Landscape)
Middle Left (Portrait)/Middle Top
(Landscape)
Lower Left (Portrait)/Upper Left
(Landscape)/Upper Right (Portrait)/
Lower Right (Landscape)
Middle Right (Portrait)/Middle Bottom
(Landscape)
Lower Right (Portrait)/Lower Left
(Landscape)
Middle Top (Portrait)/Middle Right
(Landscape)
Middle Bottom (Portrait)/Middle Left
(Landscape)
whether a print job is stapled.
“Saddle Stitch (Portrait)/Saddle Stitch
(Landscape)” can be selected only
when the Saddle Stitch Finisher is
installed.
[Continue] button Determines the selected items.
To Next Page
Loading...
