6 Printing from Macintosh
322 Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x
1) Password - Digit 1
Select the first digit of the Document ID.
2) Password - Digit 2
Select the second digit of the Document ID.
3) Password - Digit 3
Select the third digit of the Document ID.
4) Password - Digit 4
Select the forth digit of the Document ID.
5) Password - Digit 5
Select the fifth digit of the Document ID.
— Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Auto — Select this to route the output to the default tray (that is set as the default tray for
raw job in the Printer setting page of TopAccess Administrator’s page).
- Exit Tray — Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
y “Stapling and hole punching cannot be performed according to the type of the Finisher
installed and the destination setting.
y When "Auto" is select at the Destination option, the paper might be delivered to a tray
which cannot carry out stapling or hole punching according to the setting of the equip-
ment.
y “Exit Tray” is only available when no finisher is installed.
y “Tray 1” and “Tray 2” can be selected when the Finisher or Saddle Stitch Finisher are
installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off
— Select this to print without hole punches.
1
2
3
To Next Page
Loading...
