Toshiba e-STUDIO2803AM - Chapter 1 PREPARATION; Components; Front;Left Side;Inner Side

1 PREPARATION
10 Components
Components
 Front/Left side/Inner side
1. Reversing Automatic Document Feeder (RADF) (optional)
The stack of originals is scanned one sheet at a time. Both sides of the originals can be scanned. A
maximum of 50 sheets (80 g/m
2
or 20 lb. Bond) can be placed in one go. (The maximum number of sheets
that can be set may vary depending on the media type of the originals.)
 P.162 “Paper Misfeed”
2. Platen sheet
 P.178 “Regular Cleaning”
3. Original glass
Place the book-type originals and special paper such as overhead transparencies or tracing paper, as well
as plain paper.
4. Control panel
Make settings to use the various functions on this equipment.
 P.14 “Control panel”
5. Toner cartridge
For the recommended toner cartridges, refer to the Safety Information.
 P.171 “Replacing Toner Cartridge”
6. Front cover
Open this when you replace the toner cartridge.
 P.171 “Replacing Toner Cartridge”
7. Drawer
Place up to 250 sheets of plain paper (80 g/m
2
or 20 lb. Bond).
 P.23 “Loading paper in the drawer/Paper Feed Unit”
8. Paper Feed Unit (optional)
Use the Paper Feed Unit to add the second drawer. A maximum of 250 sheets (80 g/m
2
or 20 lb. Bond) of
plain paper can be placed in one go.
9. Receiving tray
10.Paper exit stopper
Stops large paper from sliding out of the receiving tray.
11.AC-IN terminal (rear)
Connect the power cable supplied with the equipment.
1
4
5
6
7
8
14
11
10
12
9
2
3
16
15
13