1.PREPARATION
Preparation 2 - Loading Paper 25
1 PREPARATION
6
While holding the green lever of the front side guide, adjust the side guides to the
paper size.
7
Push the drawer straight into the equipment slowly until it stops.
Do not catch your fingers in the drawer when closing it.
This could cause injury.
Register the paper size into the equipment.
When you load paper in the drawer for the first time, register the paper size. Be sure to register it correctly,
otherwise it could cause a paper misfeed.
For the registration, see the following page:
P.31 “Preparation 3 - Registering Paper Size and Type”
Be sure to register the paper size each time you have changed it.
Loading paper on the bypass tray
The contents of the original(s) are rotated when copied on paper of the following sizes fed from the bypass
tray.
A/B format: A3, A4-R, A5-R, B4, B5-R, FOLIO
LT format: LD, LG, LT-R, ST-R, COMP, 13"LG, 8.5"SQ
K format: 8K, 16K-R
For example, to copy an A5-size original, place the original on the original glass in A5 portrait orientation
and paper on the bypass tray in A5 landscape orientation (A5-R).
To enlarge an A4-size original to A3, place the original on the original glass in A4 portrait orientation and
A3 paper on the bypass tray.
The illustrations below are example of loading A4/LT size paper.
For the acceptable paper, see the following page:
P.19 “Acceptable paper types”
To Next Page
Loading...
