Toshiba e-STUDIO2803AM - Preparation 1 - Turning Power on; Turning on

1 PREPARATION
Preparation 1 - Turning Power ON 17
Preparation 1 - Turning Power ON
 Turning on
1
Press the power switch to “ ” (on).
Starts warming up, which takes approx. 20 seconds. When the warm-up has finished, the equipment is
ready.
If you press [START] during the warm-up, copying automatically starts after it has finished. When
the job is reserved, “COPYING” appears on the LCD screen to show you the current status.
This function cannot be accessed while “PLEASE WAIT” is being displayed.
2
The LCD screen below is shown if the equipment is managed under the department
code function.
Key in a 5-digit department code, and then press [OK].
If the department code function is enabled, press [FUNCTION CLEAR] after any operation to
prevent unauthorized use of the equipment.
For the details of the department code, see the following page:
 P.152 “Department Management”
 Turning off
Press the power switch to “ ” (off).
A4
1
READY
100%
AUTO EXPOSURE
TEXT/PHOTO
DEPARTMENT CODE
_
:12