1.PREPARATION
Preparation 2 - Loading Paper 29
1 PREPARATION
1
Place an envelope on a flat clean surface and press it with your hands in the arrow
directions as shown below to expel air from the inside.
Press it well to prevent the flap from rolling upward.
Correct bent corners of the envelope.
2
Open the bypass tray.
3
Release the lever on the left, and then load the envelope face down on the bypass tray.
Place the envelope with its flap side at the front as shown below.
Do not copy or print on the back of envelopes, otherwise it may cause a paper misfeed or soil
them or the inside of the equipment.
Printing may be uneven depending on the envelope types.
2
1
To Next Page
Loading...
