e-STUDIO350/450 DRUM RELATED SECTON 11 - 10 November 2003 © TOSHIBA TEC
11
(2) Remove the terminal, spring and wire.
Notes:
Be careful of the followings when installing the wire.
1. Insert the wire securely into the V-grooves of
the front and rear sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare hands.
(B-4) Charger wire cleaning pad
(1) Release the charger wire cleaner shaft from
the hooks of the charger wire cleaning pads.
(2) Remove the charger wire cleaning pads.
Note:
When installing, make sure that 2 charger wire
cleaning pads are away from the wire while the
charger wire cleaner shaft is at the rear side.
[C] Drum
(1) Pull out the cleaner unit and take off the main
charger ( Chapter 11.6 [A](B-1)).
(2) Release the latch and remove the cleaner stay.
Fig. 11-605
Wire
Terminal
Spring
Fig. 11-606
Fig. 11-607
Fig. 11-608
To Next Page
Loading...
