November 2003 © TOSHIBA TEC 11 - 11 e-STUDIO350/450 DRUM RELATED SECTON
11
(3) Push the lever down to the left and release
the lock. Then pull out the drum shaft.
(4) Lift up the drum and take it off.
Fig. 11-609
Notes:
1. When installing, make sure that the pressure
of cleaning blade is released with the jig.
2. Insert the head of the jig to the space shown
in the figure while pushing the blade holder.
3. Be careful not to touch or scratch the edge of
cleaning blade.
Fig. 11-611
[D] Cleaner
(D-1) Cleaning blade
(1) Take off the cleaner unit. Then take off the main
charger and drum
( Chapter 11.6 [A](B-1)[C]).
(2) Remove 2 screws and cleaning blade.
Note:
Be careful not to touch or scratch the edge of
cleaning blade.
Fig. 11-612
Fig. 11-610
To Next Page
Loading...
