e-STUDIO350/450 AUTOMATIC DUPLEXING UNIT 14 - 12 November 2003 © TOSHIBA TEC
14
(6) Remove the snap pin and slide ADU to the
rear side to take it off.
Fig. 14-506
Fig. 14-507
Fig. 14-505
(5) Disconnect 1 connector and remove 1 screw
and take off the ground wires.
[B] ADU inside rear cover
(1) Take off the ADU ( Chapter 14.5 [A]).
(2) Remove 2 screws and take off the ADU
inside rear cover.
[C] ADU opening / closing switch
(1) Take off the ADU ( Chapter 14.5 [A]).
(2) Take off the ADU inside rear cover
( Chapter 14.5 [B]).
(3) Disconnect the connector and release the latch
to take off the ADU opening / closing switch.
Fig. 14-508
Snap pin
ADU inside
rear cover
Screw
ADU opening/
closing switch
Connector
Ground wire
Screw
To Next Page
Loading...
