e-STUDIO350/450 AUTOMATIC DUPLEXING UNIT 14 - 18 November 2003 © TOSHIBA TEC
14
(4) Remove the clip on the rear side.
(3) Remove the clip, pulley, pin and belt on the
front side.
(5) Remove 2 bushings and take off the middle
transport roller.
[O] Lower transport roller
(1) Take off the ADU, ADU inside rear cover, ADU
opening / closing switch, paper guide, and
ADU cover ( Chapter 14.5 [A] to 14.5 [E]).
(2) Take off the ADU motor, the ADU gear unit
and the ADU clutch ( Chapter 14.5 [J] to
14.5 [L]).
(3) Remove the clip on the rear side.
Fig. 14-529
Fig. 14-530
Fig. 14-531
Fig. 14-532
Pin
Clip
Pulley
Belt
Clip
Bushing
Middle transport roller
Bushing
Clip
To Next Page
Loading...
