November 2003 © TOSHIBA TEC 14 - 17 e-STUDIO350/450 AUTOMATIC DUPLEXING UNIT
14
(5) Remove 4 screws and take off the bracket.
(7) Remove the clip on the front side.
(8) Remove 2 bushings and take off the upper
transport roller.
(6) Remove the clip, pulley, pin and belt on the
rear side.
Fig. 14-525
Fig. 14-526
Fig. 14-527
Fig. 14-528
[N] Middle transport roller
(1) Take off the ADU, ADU inside rear cover,
ADU opening / closing switch, paper guide,
and ADU cover
( Chapter 14.5 [A] to 14.5 [E]).
(2) Take off the ADU board.
Screw
Bracket
Pin
Pulley
Belt
Clip
Clip
Bushing
Bushing
Upper transport roller
ADU board
To Next Page
Loading...
