e-STUDIO350/450 OUTLINE OF THE MACHINE 2 - 34 November 2003 © TOSHIBA TEC
2
2
Fig. 2-536
[F] High-voltage transformer
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Disconnect 7 connectors.
(3) Remove 2 screws and release 2 locking sup-
ports. Then take off the high-voltage trans-
former.
Note:
When installing, make sure to match the col-
ors of connectors and harnesses according
to the color instruction on the board.
Fig. 2-537
[G] Noise filter
(1) Take off the rear cover and right lower cover
( Chapter 2.5.1 [C][O]).
(2) Disconnect 4 connectors. Remove 1 screw and
1 washer. Then take off the noise filter.
White Black
To Next Page
Loading...
