November 2003 © TOSHIBA TEC 2 - 33 e-STUDIO350/450 OUTLINE OF THE MACHINE
2
Fig. 2-535
[D] Switching power supply
(1) Take off the left cover ( Chapter 2.5.1 [J]).
(2) Remove 2 screws. Disconnect 2 connectors
with lock on the front side and 1 connector
while releasing the harness from the holder
on the right side of the bracket.
(3) Disconnect 3 connectors while the switching
power supply is pulled out to the front and take
off the switching power supply.
Fig. 2-533
Fig. 2-532
Fig. 2-534
(6) Remove 12 screws, take off the NIC board
and SYS board.
SYS board
NIC board
[E] Power supply cooling fan
(1) Take off the left cover ( Chapter 2.5.1 [J]).
(2) Remove 2 screws and take off the power sup-
ply cooling fan on the switching power sup-
ply.
Note:
When installing, pay attention to the direction
of the wind from the fan.
To Next Page
Loading...
