e-STUDIO350/450 OUTLINE OF THE MACHINE 2 - 32 November 2003 © TOSHIBA TEC
2
2
(5) Remove 5 screws and take off the SYS board
with the whole case.
(4) Release all the harnesses from harness
clamps and holders on the case.
Fig. 2-528
(5) Remove 4 screws and take off the hard disk.
Fig. 2-529
Fig. 2-530
Fig. 2-531
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Take off the hard disk with the whole SYS
board lower cover ( Chapter 2.5.2 [B]).
(3) Disconnect 4 connectors.
[C] System control PC board (SYS board)
To Next Page
Loading...
