November 2003 © TOSHIBA TEC 2 - 31 e-STUDIO350/450 OUTLINE OF THE MACHINE
2
(4) Release all the harnesses from the harness
clamps and holders on the case.
(5) Remove 5 screws and take off the LGC board
with the whole case.
Fig. 2-524
Fig. 2-525
[B] Hard disk
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Loosen 9 screws and take off the SYS board
upper cover.
Fig. 2-526
Fig. 2-527
(3) Disconnect 2 connectors.
(4) Loosen 5 screws and take off the hard disk
with the whole SYS board lower cover.
To Next Page
Loading...
