e-STUDIO350/450 OUTLINE OF THE MACHINE 2 - 30 November 2003 © TOSHIBA TEC
2
2
Fig. 2-521
Fig. 2-522
Fig. 2-523
2.5.2 PC boards
[A] Logic PC board (LGC board)
(A-1) LGC board
(1) Take off the rear cover (
Chapter 2.5.1 [C]).
(2) Loosen 8 screws and take off the LGC board
cover.
(3) Disconnect 15 connectors and 1 connector
with lock.
(4) Remove 4 screws and release 2 locking sup-
ports. Then take off the LGC board.
(A-2) LGC board unit
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Loosen 8 screws and take off the LGC board
cover.
(3) Disconnect 15 connectors, 1 connector with
lock and 1 joint connector fixed to the case.
Fig. 2-520
Lock connector
Lock connector
To Next Page
Loading...
