Toshiba e-STUDIO500P - Page 105

Diagnostic information 2-69
238 .00 Paper is covering one of
the duplex sensors
during a reset.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .01 Duplex input sensor
covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .02 Duplex exit sensor
covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .03 Duplex input and exit
sensors covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .04 Duplex doublefeed
sensor covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .05 Duplex doublefeed
sensor covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
238 .06 Duplex doublefeed and
exit sensors covered.
• Media left in the duplex and
Continue selected.
• Sensor is having mechanical or
electrical problems.
• Remove any sheets from
the duplex option.
• Try the duplex option again.
If it fails, try another duplex
option, if available. If one is
not available, replace the
duplex option.
User attendance messages—paper jams and paper handling errors (2xx.xx)
Error
code
Sub
codes
Description Possible causes Action