2-126 Service Manual
System board service check
Warning: When replacing any one of the following components:
• Operator panel assembly (or upper front cover)
• System board assembly
• Interconnect card assembly
Only replace one component at a time. Replace the required component and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one or the printer will be
rendered inoperable.
Warning: Never install and remove components listed above as a method of troubleshooting components.
Once a component has been installed in a printer, it can not be used in another printer. It must be
returned to the manufacturer.
To Next Page
Loading...
Need help?
General