Repair information 4-19
Laser cover removal
1.
Remove the left door. See “Left door removal” on page 4-6.
2. Remove the right cover. See “Right cover removal” on page 4-8.
3. Remove the paper support. See “Paper support removal” on page 4-5.
4. Remove the redrive cap. See “Redrive cap cover removal” on page 4-5.
5. Press the fuser wiper cover latch, and remove the cover.
6. Remove the screw (A) at the rear of the printer and the larger screw (B) at the front on the right side.
7. Remove the two mounting screws (C) from the left side.
A
To Next Page
Loading...
