4-12 Service Manual
6. Disconnect the cables.
Note: It may be necessary to remove the operator panel cable from the cable clip (C) to be able to
disconnect the cable from the operator panel.
7. Remove the upper front cover.
Note: If you are replacing the upper front cover, remove the upper front cover outer bezel and upper front
cover latch. Otherwise, carefully set the upper front cover aside to avoid scratching the bezel or loosening
the latch and spring.
Note: When removing the upper front cover outer bezel, use care not to lose or drop the clear plastic inner
bezel.
Installation notes:
• Lift the paper support before installing the upper front cover.
• Make sure the operator panel cable is in the cable clip (C), if removed.
To Next Page
Loading...
