Toshiba e-STUDIO5015AC - To Avoid Copying Blank Page of Original Scanned with DF

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-90
2.21 To Avoid Copying Blank Page of Original Scanned with DF
 Explanation
When the original is scanned with the DF, blank pages included in the original are also copied. To copy
while omitting the blank pages automatically, the Blank Omit Pages function must be set and its
threshold for judging if the page is blank or not must be adjusted. However, colored originals with no text
or images are not omitted even this adjustment was performed because they cannot be detected as
“blank pages” with this function.
Target originals
• The back side of an original with dark images on its front side (the dark images can be seen
through the back side) or an original with light color
• An original with only 3 letters in 10.5 pt. (an original that is omitted as a blank page with the default
setting)
 Procedures
• You can start with any of the steps. However, it is recommended to perform the steps in order as listed
below.
• Both the service technician and the user can perform step (1) and (2).
• Only the service technician can perform step (3) and (4).
Before adjustment After adjustment
When the original is scanned with the DF,
blank pages included in the original are
also copied.
The blank pages are omitted.