Toshiba e-STUDIO5015AC - To Make the Pale Area of the Original Look Darker and Sharper (to Improve the Highlight Reproducibility)

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-28
2.6 To Make the Pale Area of the Original Look Darker and
Sharper (To improve the highlight reproducibility)
 Explanation
Perform the copy density adjustment and background adjustment, in order to make the pale area
(highlight) of the original look darker and sharper on the copy.
 Procedures
• You can start with any of the procedures. But it is recommended to perform the procedures in order, as
listed below. You can perform one procedure in conjunction with another. But if this changes the image
quality more than required or loses the effectiveness of the adjustment, restore the settings made in
the previously performed procedure to the original ones. Then perform other procedures.
• Both the service technician and the user can perform procedures (1) and (3).
• Only the service technician must perform procedures (2), (4) and (5).
(1) Press [Image] tab on the Copy mode. Press [Background adjustment].
Press [Dark] to darken the background.
After increasing the background density, copy and check the copy image quality.
With the background density set to the maximum, if further image quality adjustments are still
necessary, the service technician must perform the next procedure.
Before adjustment After adjustment
The splashing area (highlight) is blurred.
A clear copy image of the splashing area is
obtained.