Toshiba e-STUDIO5015AC - Toner Used Amount Adjustment

3.Printer-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
3-24
3.1.9 Toner Used Amount Adjustment
When printing on paper with a rough surface, the problem of the toner coming off of can be suppressed
from dark lines created by overlapping of the 4 color toners.
* This adjustment will have an effect only on Auto or Color mode printing.
Select [05 ADJUSTMENT MODE] and change the setting value for [8070]/[8071] or [8089]/[8090] to a
smaller one, so that the limit value of the maximum toner adhering amount will become small.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and
Halftone).
• Printing on Mac is performed in PostScript.
• Set the value in increments of approximately 30, while checking the printouts until the optimum
value is obtained.
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
Resolution Halftone
[05]
Code
Subcode
Recom
mended
value
Acceptable
value
range
Default
e-STUDIO
2010AC/
2510AC
e-STUDIO
2515AC/
3015AC/
3515AC/
4515AC/
5015AC
600 dpi
Smooth 05-8071
0 to
4/7/8/11/12
0 to 12
Set a
value
smaller
than
the
default.
0 to 255 128
Detail 05-8070
0 to
4/7/8/11/12
0 to 12
1200 dpi
Smooth 05-8090
0 to
4/7/8/11/12
0 to 12
Set a
value
smaller
than
the
default.
0 to 255 128
Detail 05-8089
0 to
4/7/8/11/12
0 to 12
Subcode Paper type
0 Plain paper
1 Thick paper
2 Recycled paper
3 Thick paper 1
4 Thick paper 2
5 Thick paper 3*
6 Thick paper 4*
7 Special paper 1
8 Special paper 2
9 Special paper 3*
10 Thin paper*
11 Envelope
12
Transparency
(OHP film)
PCL
PS
XPS Mac