3.Printer-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
3-83
To adjust the image quality on Black and White printing
(“Black and White” is selected from among the “Color” options on the PCL or PS or XPS printer
driver. “Mono” is selected from among the “Color Type” options on Mac.)
• The “Color” options are available in the “Basic” tab on the PCL, PS and XPS printer drivers.
The “Color Type” options are available in the “Color Settings 1” menu in the print dialog box on
Mac.
(a) Select [05 ADJUSTMENT MODE]. Increase the value for codes [7307] or [7302] to adjustment
the upper limit of the image density in the toner save mode.
• Printing on Mac is performed in PostScript. (See the “PS” row in the table below.)
• Set the value in increments of approximately 30, while checking the printouts until the
optimum value is obtained.
Caution after the adjustment
The adjustment may possibly cause an increase of the amount of toner used (if the image density is
increased) or provide faint print images (if the image density is decreased). Therefore, carefully perform
the adjustment, while checking the printouts.
Resolution PDL [05] code Subcode
Recommended
value
Acceptable
value range
Default
600 dpi
PS 05-7307 0
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
0 to 255 176
PCL 05-7307 1
XPS 05-7307 2
1200 dpi PS 05-7302 0
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
0 to 255 176
To Next Page
Loading...
