Toshiba e-STUDIO5015AC - Page 254

3.Printer-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
3-94
(2) Select [05 ADJUSTMENT MODE]. Change the values for codes [8023 to 8041] to adjust the color
density.
• Adjust the value for the [05] code corresponding to the print option to be applied (color selected in
the “Twin Color” option).
Ex.:
When printing is performed with the following options selected: “Color” option = “Twin Color”,
“Details” option = “Red”
Adjust the values for the following [05] codes: [8033] for Y (Yellow), [8034] for M (Magenta)
and [8023] for K (Black)
• Set the value in increments of approximately 20, while checking the printouts until the optimum
value is obtained.
Selected
color
Color to
adjust
[05]
code
Sub
code
Recommended
value
Acceptable
value range
Default
Red
Y (Yellow) 05-8033 0/1/2
Set a value larger
than 128 to
increase the
density.
Set a value
smaller than 128
to decrease the
density.
0 to 255 128
M (Magenta) 05-8034 0/1/2
C (Cyan) 05-8035 0/1/2
Green
Y (Yellow) 05-8036 0/1/2
M (Magenta) 05-8037 0/1/2
C (Cyan) 05-8038 0/1/2
Blue
Y (Yellow) 05-8039 0/1/2
M (Magenta) 05-8040 0/1/2
C (Cyan) 05-8041 0/1/2
Cyan
Y (Yellow) 05-8024 0/1/2
M (Magenta) 05-8025 0/1/2
C (Cyan) 05-8026 0/1/2
Magenta
Y (Yellow) 05-8027 0/1/2
M (Magenta) 05-8028 0/1/2
C (Cyan) 05-8029 0/1/2
Yellow
Y (Yellow) 05-8030 0/1/2
M (Magenta) 05-8031 0/1/2
C (Cyan) 05-8032 0/1/2
Red/Green/
Blue/Cyan/
Magenta/
Yellow
K (Black) 05-8023 0/1/2