1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-39
(5) Temporarily tighten the screw [9] removed in step (4)
into the screw hole [3].
(6) Select the closest value to the tilted volume “A-B” from the following table and check the scales of
the frame and the LSU holder to be aligned.
Scale position to be aligned Tilted volume (A-B): [Unit: mm]
Frame LSU holder 297 mm (A3) 279 mm (LD)
Front
Eighth Eighth 1.12 1.04
Seventh Seventh 0.98 0.91
Sixth Sixth 0.84 0.78
Fifth Fifth 0.7 0.65
Fourth Fourth 0.56 0.52
Third Third 0.42 0.39
Second Second 0.28 0.26
First First 0.14 0.13
Center 0 0 0 0
Rear
First First -0.14 -0.13
Second Second -0.28 -0.26
Third Third -0.42 -0.39
Fourth Fourth -0.56 -0.52
Fifth Fifth -0.7 -0.65
Sixth Sixth -0.84 -0.78
Seventh Seventh -0.98 -0.91
Eighth Eighth -1.12 -1.04
Remarks
Moving approx.
0.14 mm per 1
scale
Moving approx.
0.13 mm per 1
scale
To Next Page
Loading...
