4 Replacement Procedures 4.20 Display portion
To install the display portion, follow the steps below and refer to Figure 4-30 to 4-32.
1. Set the power switch holder to the slot.
2. Set the sensor board to the application button holder and connect the sensor cable to
the connector on the sensor board.
3. Set the application button holder to the slot.
4. Set the display portion to the middle frame.
CAUTION: An insulator is not put on the back of a new middle frame. Stick a new
insulator as shown in the figure below.
Insulator
4-52 [CONFIDENTIAL] PORTÉGÉ R500 Maintenance Manual (960-634)
To Next Page
Loading...
