Toshiba Q9+ - Page 132

120 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
BIN Input Point 1 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the speed of the BIN input termi-
nals when the BIN terminals are used as the control input.
This parameter sets BIN Input Point 1 Frequency and is the fre-
quency that is associated with the setting of BIN Input Point 1
Setting.
See BIN Input Point 1 Setting (F228) for additional information on
this parameter.
Direct Access Number —
F229
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
BIN Input Point 2 Setting
Program Frequency Speed Reference Setpoints
This parameter is used to set the speed of the BIN input termi-
nals when the BIN terminals are used as the control input.
This parameter sets the BIN input signal that is associated with
BIN Input Point 2 Frequency.
This value is entered as 0% to +100% of the BIN input signal
range.
See BIN Input Point 1 Setting (F228) for additional information on
this parameter.
Direct Access Number —
F230
Parameter Type — Numerical
Factory Default — 100
Changeable During Run — Yes
Minimum — 0
Maximum — 100
Units — %
BIN Input Point 2 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the speed of the BIN input termi-
nals when the BIN terminals are used as the control input.
This parameter sets BIN Input Point 2 Frequency and is the fre-
quency that is associated with the setting of BIN Input Point 2
Setting.
See BIN Input Point 1 Setting (F228) for additional information on
this parameter.
Direct Access Number —
F231
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Maximum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
F229 – F234