Toshiba Q9+ - Page 134

122 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
PG Input Point 1 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the speed of the PG input termi-
nals when the PG terminal is used as the control input.
This parameter sets PG Point 1 Frequency and is the frequency
that is associated with the setting of PG Point 1 Setting.
See PG Point 1 Setting (F234) for additional information on this
parameter.
Direct Access Number —
F235
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
PG Input Point 2 Setting
Program Frequency Speed Reference Setpoints
This parameter is used to set the direction and speed of the PG
input terminals when the PG terminals are used as the control
input.
This parameter sets the PG input signal that is associated with
PG Point 2 Frequency.
This value is entered as 0% to 100% of the PG input signal
range.
See PG Point 1 Setting (F234) for additional information on this
parameter.
Direct Access Number —
F236
Parameter Type — Numerical
Factory Default — 100
Changeable During Run — Yes
Minimum — 0
Maximum — 100
Units — %
PG Input Point 2 Frequency
Program Frequency Speed Reference Setpoints
This parameter is used to set the direction and speed of the PG
input terminals when the PG terminals are used as the control
input.
This parameter sets PG Point 2 Frequency and is the frequency
that is associated with the setting of PG Point 2 Setting.
See PG Point 1 Setting (F234) for additional information on this
parameter.
Direct Access Number —
F237
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
F235 – F240