Toshiba Q9+ - Page 142

130 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
UP/DOWN Frequency (up) Frequency Step
Program Frequency UP/DOWN Frequency Functions
This parameter sets the frequency increase amount for each acti-
vation of the UP/DOWN Frequency (up) terminal activation. The
rate of the frequency increase is set at Acceleration Time 1
(F009).
See F264 for additional information on this parameter.
Direct Access Number —
F265
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
UP/DOWN Frequency (down) Response Time
Program Frequency UP/DOWN Frequency Functions
This parameter sets the system-response delay to the initial acti-
vation of the discrete input terminal UP/DOWN Frequency
(down). Also sets the activation delay of subsequent terminal
activations of the UP/DOWN Frequency (down) terminal during
an activate-and-hold.
See F264 for additional information on this parameter.
Direct Access Number —
F266
Parameter Type — Numerical
Factory Default — 0.1
Changeable During Run — Yes
Minimum — 0.0
Maximum — 10.0
Units — Seconds
UP/DOWN Frequency (down) Frequency Step
Program Frequency UP/DOWN Frequency Functions
This parameter sets the frequency decrease amount for each
activation of the UP/DOWN Frequency (down) terminal activa-
tion. The rate of the frequency decrease is set at Deceleration
Time 1 (F010).
See F264 for additional information on this parameter.
Direct Access Number —
F267
Parameter Type — Numerical
Factory Default — (ASD-Depen-
dent)
Changeable During Run — Yes
Minimum — 0.00
Maximum — Maximum Freq.
(F011)
Units — Hz
Initial UP/DOWN Frequency
Program Frequency UP/DOWN Frequency Functions
At power up or after a reset, this parameter setting is used to pro-
vide a starting frequency for the UP/DOWN Frequency function.
See F269 for additional information on this parameter.
Direct Access Number —
F268
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F265 – F269