Toshiba Q9+ - Page 175

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 163
Power Running Torque Limit 1
Program Torque Torque Limit Settings
This parameter determines the source of the control signal for the
positive torque limit setting.
If F441 is selected, the value set at F441 is used as the Power
Running Torque Limit 1 input.
Settings:
1 — V/I
2 — RR
3 — RX
4 — F441 (Setting)
Direct Access Number —
F440
Parameter Type — Selection List
Factory Default —F441 (Setting)
Changeable During Run — Yes
Power Running Torque Limit 1 Level
Program Torque Torque Limit Settings
This parameter provides a value for the Power Running Torque
Limit 1 setting if F441 is selected at parameter F440.
This value provides the positive torque upper limit for the 1 motor.
Direct Access Number —
F441
Parameter Type — Numerical
Factory Default — 250.00 (Dis-
abled)
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00 (Disabled)
Units — %
Regenerative Braking Torque Limit 1
Program  Torque Torque Limit Settings
This parameter determines the source of the Regenerative
Torque Limit control signal.
If F443 is selected, the value set at F443 is used as the Regener-
ative Torque Limit setting.
Settings:
1 — V/I
2 — RR
3 — RX
4 — F443 (Setting)
Direct Access Number —
F442
Parameter Type — Selection List
Factory Default — F443 Setting
Changeable During Run — Yes
Regenerative Braking Torque Limit 1 Level
Program Torque Torque Limit Settings
This parameter provides a value to be used as the Regeneration
Torque Limit 1 if F443 is selected at parameter F442.
Set this parameter to 250% to disable this function.
Direct Access Number —
F443
Parameter Type — Numerical
Factory Default — 250.0 (Dis-
abled)
Changeable During Run — Yes
Minimum — 0.0
Maximum — 250.0
Units — %
F440 – F450