Toshiba Q9+ - Page 224

212 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Device Name Data 6
Program Communications Ethernet Settings
See F792 for information on this parameter.
Direct Access Number —
F797
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Device Name Data 7
Program Communications Ethernet Settings
See F792 for information on this parameter.
Direct Access Number —
F798
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Device Name Data 8
Program Communications Ethernet Settings
See F792 for information on this parameter.
Direct Access Number —
F799
Parameter Type — Numerical
Factory Default — 0000
Changeable During Run — Yes
Minimum — 0000
Maximum — FFFF
Baud Rate (2-Wire RS485)
Program Communications Communication Settings
This parameter plays a role in the setup of the communications
network by establishing the Baud Rate of the communications
link.
The communications network includes other ASDs and Host/
Control computers that monitor the status of the ASD(s), trans-
fers commands, and loads or modifies the parameter settings of
the ASD.
Changes made to this parameter require that the power be
cycled (off then on) for the changes to take effect.
Settings:
0 — 9600
1 — 19200
2 — 38400
Direct Access Number —
F800
Parameter Type — Selection List
Factory Default — 19200
Changeable During Run — Yes
Units — bps
F797 – F801