Toshiba Q9+ - Page 233

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 221
Baud Rate Monitor Right Port (Ethernet)
Program Communications Ethernet Settings
This parameter establishes the baud rate detection setting
of the right port.
Settings:
0 — Automatic Detection
1 — 10 Mbps Full
2 — 10 Mbps Half
3 — 100 Mbps Full
4 — 100 Mbps Half
Direct Access Number —
F822
Parameter Type — Selection List
Factory Default —Automatic Detection
Changeable During Run — Yes
Baud Rate Monitor Left Port (Ethernet)
Program Communications Ethernet Settings
This parameter establishes the baud rate detection setting
of the left port.
Settings:
0 — Automatic Detection
1 — 10 Mbps Full
2 — 10 Mbps Half
3 — 100 Mbps Full
4 — 100 Mbps Half
Direct Access Number —
F823
Parameter Type — Selection List
Factory Default —Automatic Detection
Changeable During Run — Yes
RS485 Send Delay Time (4-Wire RS485)
Program Communications Communication Settings
This parameter sets the RS485 response delay time.
Changes made to this parameter require that the power be
cycled (off then on) for the changes to take effect.
Direct Access Number —
F825
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.00
Units — Seconds
F822 – F826