Toshiba Q9+ - Page 267

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 255
Table 10. Output Terminal Assignments for the FP, AM, FM, MON1, and MON2 Output Terminals.
Output Meter Terminal Assignments and Display Item Selections
Selection/Comm
Number
Terminal Assignment Name
Selection/Comm
Number
Terminal Assignment Name
0 Output Frequency 31 Data from Communications
1 Frequency Command 32 185% Meter Adjust Value
2 Output Current 33 250% Meter Adjust Value
3 DC Bus Voltage 34 Input Watt Hour
4 Output Voltage 35 Output Watt Hour
5 Compensated Frequency 45 Gain Display
6
Speed Feedback
(Real-Time)
46 My Function Monitor 1 Without Sign
7
Speed Feedback
(1 Sec Filter)
47 My Function Monitor 2 Without Sign
8 Torque 48 My Function Monitor 3 With Sign
9 Torque Command 49 My Function Monitor 4 With Sign
11 Torque Current 50 Signed Output Frequency
12 Excitation Current 51 Signed Frequency Command (pre-PI)
13 PID Feedback Value 52 Signed Compensated Frequency
14 Motor Overload Ratio 53 Signed Speed Feedback (Real-Time)
15 ASD Overload Ratio 54
Signed Speed Feedback
(1 Sec Filter)
16
DBR Overload Ratio (not
used)
55 Signed Torque
17 DBR Load Ratio (not used) 56 Signed Torque Command
18 Input Power 58 Signed Torque Current
19 Output Power 59 Signed PID Feedback Value
23 Option V/I (AI2 Option) Input 60 Signed RX Input
24 RR Input 61 Signed RX2 (AI1 Option) Input
25 V/I Input 62 Signed 100% Meter Adjust Value
26 RX Input 63 Signed 185% Meter Adjust Value
27 RX2 (AI1 Option) Input 64 Signed 250% Meter Adjust Value
28 FM Output 74 Analog Output MON1 (Extended I/O)
29 AM Output 75 Analog Output MON2 (Extended I/O)
30 100% Meter Adjust Value 76 Pulse Input RP (Extended I/O)
Output
Frequency
Output Current