Toshiba Q9+ - Page 272

260 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Table 14. Input Function Target Selections and the Associated Communications Number.
Input Setting/Communication Number
Function Resolution/Unit
FM/AM/FP
Input Set-
ting
Comm.
Number
Monitor Dis-
play Input
Setting
Comm.
Number
2000 FD00 3000 FE00 Output Frequency 0.01 Hz
2002 FD02 3002 FE02 Frequency Reference 0.01 Hz
2003 FD03 3003 FE03 Output Current 0.01%
2004 FD04 3004 FE04 DC Bus Voltage 0.01%
2005 FD05 3005 FE05 Output Voltage 0.01%
2015 FD15 3015 FE15 Compensated Frequency 0.01 Hz
2016 FD16 3016 FE16 Speed Feedback (Real-Time)
(see Note 1) 0.01 Hz
2017 FD17 3017 FE17
Speed Feedback (1 Sec Filter)
(see Note 1)
0.01 Hz
2018 FD18 3018 FE18 Torque (see Note 2) 0.01%
2019 FD19 3019 FE19 Torque Command
(see Note 2) 0.01%
2020 FD20 3020 FE20 Torque Current (see Note 2) 0.01%
2021 FD21 3021 FE21 Excitation Current 0.01%
2022 FD22 3022 FE22 PID Feedback Value 0.01 Hz
2023 FD23 3023 FE23 Motor Overload Ratio 0.01%
2024 FD24 3024 FE24 ASD Overload Ratio 0.01%
2025 FD25 3025 FE25 DBR Overload Ratio (not used) 1%
2028 FD28 3028 FE28 DBR Load Ratio (not used) 1%
2029 FD29 3029 FE29 Input Power 0.01 kW
2030 FD30 3030 FE30 Output Power 0.01 kW
3031 FE31 Pattern Operation Group Number 0.1
3032 FE32 Pattern Operation Cycles Remaining 1
3033 FE33 Pattern Operation Preset Speed Number 1
3034 FE34
Pattern Operation Preset Speed Time
Remaining
0.1
2050 FD50
Light-Load High-Speed Load Torque Mon-
itor 1
0.01%
2051 FD51
Light-Load High-Speed Load Torque Mon-
itor 2
0.01%
3035 FE35 RR Input 1%
3036 FE36 V/I Input 1%
3037 FE37 RX Input
(see Note 2) 1%
3038 FE38
RX2 (AI1 Option) Option Input
(see Note 2)
1%
Note 1: If no PG feedback is used, an estimated speed value is displayed.
Note 2: My Function cannot process negative values. A negative value is processed by My Function as
an absolute value.