System Configuration and Menu Options
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 37
Accel/Decel Group — One of two Accel/Decel
profiles may be selected and run. Each of the
Accel/Decel profiles is comprised of three user
settings: Acceleration, Deceleration, and Pattern.
Expanded descriptions of these parameters may be
found in the section titled Direct Access Parameter
Information on pg. 73 (see F009).
PID Control — This setting enables or disables the
PID feedback function.
Torque Limit Group — This group is used to select
preset positive torque limits to apply to the active
motor (of a multiple motor configuration). The
settings may be accessed at F440, F441, F442,
and F443, respectively.
VLP Technology Control — This setting enables
or disables the Virtual Linear Pump function.
To Next Page
Loading...
