Toshiba Q9+ - Page 79

BACnet Setup
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 67
BACnet
®
I/O, and Values
Table 4. BACnet
®
Binary Inputs.
Digital Input
Terminal
Binary Input
Object ID
Object
Name
Description Status Access
F
Binary Input
#6
(BI6)
F Status
Monitors the status of the F input
terminal (Forward Run Command)
On/Off R
R
Binary Input
#7
(BI7)
R Status
Monitors the status of the R input
terminal (Reverse Run Command)
On/Off R
ST
Binary Input
#8
(BI8)
ST Status
Monitors the status of the ST input
terminal (Standby Command)
On/Off R
RES
Binary Input
#9
(BI9)
RES
Status
Monitors the status of the RES
input terminal (Fault Reset
Command)
On/Off R
S1
Binary Input
#10
(BI10)
S1 Status
Monitors the status of the S1 input
terminal (Fire-speed Command)
On/Off R
S2
Binary Input
#11
(BI11)
S2 Status
Monitors the status of the S2 input
terminal (Preset Speed Bit 2)
On/Off R
S3
Binary Input
#12
(BI12)
S3 Status
Monitors the status of the S3 input
terminal (Damper Closed
Feedback)
On/Off R
S4
Binary Input
#13
(BI13)
S4 Status
Monitors the status of the S4 input
terminal (Emergency Off (NC))
On/Off R
LI5*
Binary Input
#14
(BI14)
LI5 Status
Monitors the status of the LI5
input terminal
On/Off R
LI6*
Binary Input
#15
(BI15)
LI6 Status
Monitors the status of the LI6
input terminal
On/Off R
LI7*
Binary Input
#16
(BI16)
LI7 Status
Monitors the status of the LI7
input terminal
On/Off R
* The ETB004Z expansion I/O card is required to use this input.
R = Read-only