User’s Manual 7-5
HW Setup
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]Sets PXE as the protocol (Default).
[RPL]Sets RPL as the protocol.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you
can turn on the computer by pressing any key. It is effective only for the
internal keyboard and only when the computer is in standby mode.
CPU
This function lets you set the CPU operating mode.
Dynamic CPU Frequency Mode
This option lets you choose from the following settings:
■ If a boot command is not found on the first detected HDD, the system
will not boot from the other HDD. It will search the next device in the
boot priority for a boot command.
■ Although, generally, most models have two hard disks installed, some
models have only one hard disk. In the case of models with one hard
disk, this setting item will not be displayed.
Network Boot Protocol is not displayed for Gigabit Ethernet LAN.
Enabled Enables the Wake-up on Keyboard function.
Disabled Disables the Wake-up on Keyboard function
(Default).
This option is displayed only for models with an Intel
®
Core
™
Duo
Processor.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When
the computer is in use, CPU operation is
automatically switched when necessary
(Default).
To Next Page
Loading...
Need help?
General